They can be received up to 6 hours.

Have questions?

Easter delivery information

Last delivery: April 2.
Break: April 3-5.
First delivery: April 8.

How can you easily install the stone window sills you ordered?

Share this page

Installing the stone ledges we manufacture is even easier than you might think. We’ve put together a few very important tips for you so that you can easily install any of the stone ledges you purchase from us.

Please note that before ordering stone window sills, you should carefully read the instructions provided in the stone window sill designer to ensure you order the correct size! After the window sills are delivered or picked up, please use this guide to install them!

OUTER SILL

Hand rails

1. Prepare the chosen location for the stone ledge!

Prepare the surface where the molding you want to place: the window from the bottom of the appropriate thickness to form (sill thickness + 1.5-2cm), and the bilateral overhang place of prepare (brick, apartments chisel with carvings – insulation in the case of cut out with a scalpel)! Try on "dry" the kőpárkányt. If it is considered appropriate found (slope) remove and prepare the installation.! Clean off the surface, (for dusting) wet sponge and wipe!

2. Waterproofing design

Cut size of the gap closing tape (length and width), and then insert under the window or the crafted cornice host into and glue (CM 16 to 25) evenly lubricate inside. This helps to prevent possible leaking water from entering the building.

3. Installation of the stone ledge

In the description pursuant to finally CM 16 to 25 with glue evenly on the horizontal surface of the proper thickness, and then insert the appropriate size kőpárkányt! The kőpárkány place to right to use a rubber mallet or small moving the desired place to adjust. The kőpárkány location: under the window by sliding 1 cm, or crafted cornice host in the interior. Bubble level to adjust the appropriate gradients (0.8 – 1 cm), measured from the parallel from the window, and the bilateral overhang accuracy check!

4. Final touches

Apply CM 16-25 adhesive to both sides of the wall joint and the joint beneath the stone ledge, then wash the surface of the stone ledge with a damp sponge! Once the stone surface has dried, seal the gap between the stone ledge and the window with OTTO Seal silicone (we recommend the colorless variety, as it will take on the color of the stone)! Then, impregnate the entire surface with Akemi natural stone impregnating agent! We recommend repeating this process annually.

Once the stone ledge has been installed, you can admire the beauty of your building! This will increase the value of your home, enhance its appearance, and protect the wall from water damage.

Check out our video guide! We'll show you, step by step, how to install your stone ledge without a professional!

Need more help?

Call us at +36 30 277 8210 phone number or write to the info@parkanyos.hu e-mail address.